Skip to content
Translate Ideas and Comments
Choose language:
There was an error during translation
← SMART Technologies Customer Feedback Program

SMART Board Hardware

SMART Board Hardware

Categories

JUMP TO ANOTHER FORUM

(thinking…)

Feedback for SMART Board interactive displays and interactive whiteboards.

(thinking…)

Enter your idea and we'll search to see if someone has already suggested it.

If a similar idea already exists, you can support and comment on it.

If it doesn't exist, you can post your idea so others can support it.

Enter your idea and we'll search to see if someone has already suggested it.

  • Hot ideas
  • Top ideas
  • New ideas
  • My feedback

5 results found

  1. Inking feature while on freeze mode on MX-V5 like on V3 and V4. This feature is for Chromebook users.

    Since Chromebook users can't install SMART Drivers, this inking feature on freeze mode is a must. With MX-V3 and V4, this feature is loved by teachers but with V5, this feature is no longer available.
    11 votes
    planned  ·  5 comments  ·  Admin →
    How important is this to you?

  2. front panel buttons

    To be able to disable front panel control buttons on a SMART MX series panels. This is a customer request
    9 votes
    planned  ·  0 comments  ·  SMART Board MX Series  ·  Admin →
    How important is this to you?

  3. Remotely Configure MX System Update Settings from SMART Remote Management

    We have 150 MX boards (66% V5), where it would be of benefit of us to manage the board's system update settings via the Remote Management system.

    Our preferred method of updating the boards would be to test an update on a few boards before allowing the update to roll out to the rest of our boards.

    Rather than visit each board, we would like to be able to configure these settings via policies in Smart Remote Management.
    4 votes
    planned  ·  1 comment  ·  SMART Board MX Series  ·  Admin →
    How important is this to you?

  4. Remove lock pin

    Please give us a way to remove lock pins. It's easy enough to create and change the lock pin, but there's no way to remove it. Now that I've been able to set up my Smart card, I don't need a lock pin. I'd like to remove the pin from my board and there's currently no way to do so.
    4 votes
    0 comments  ·  SMART Board Interactive Whiteboards  ·  Admin →
    How important is this to you?

  5. MX V5 - Enable support for HDMI-CEC, Default Input and Wake on source

    MX V5 in use in meeting room scenarios often have peripherals attached that need to utilize HDMI-CEC, Default input or Wake on source.

    One very relevant scenario is Microsoft Teams Rooms Devices. These control the display based on room occupancy using HDMI-CEC & wake on source. The default input option would be very useful, so make the MTR device the primary input. Users can then switch to iQ when needed..
    3 votes
    planned  ·  1 comment  ·  SMART Board MX Series  ·  Admin →
    How important is this to you?
  • Don't see your idea?